Knowledge Base Detail

KB00131: PDM 550 does not cause P2 alarm on SA3U with V14 firmware

The PDM card may set to the old ID value of 7 but that it should be set to 9 for SAM14 firmware.  There is a jumper area, two rows of four pins, near the module back-plane connector, with pairs numbered 60, 61, 62, 63.  The numbers may not be clearly visible where jumpers are fitted.  Four jumpers are possible, each from one pin in one row to the corresponding pin in the other row.  Fit a jumper across the pair at 60 and another across the pair at 63.

About Brandywine Communications

Brandywine Communications Inc. offers superior products to the time and frequency marketplace. Our mission is to provide the finest equipment coupled with excellent before and after sale service.

Find Out More...

Contact Us

Brandywine Communications
Ultra-Precision Time & Frequency

1153 Warner Ave
Tustin, CA 92780
Mail: info@brandywinecomm.com
Phone: 714.755.1050


TOP

Translate

enfrdeitptrues
Translate